|
|
Post by heinous on Aug 22, 2010 19:35:31 GMT -5
I now have my external mod shop up again. I can lighten-up heavy parts, add external rails, drill and tap new holes, re-tap bad holes, and make so-so looking guns look kick-butt!( For example my SCAR- Lightened by 2 lbs with awesome looks ) I love to add rail segments to pistol tops for red dot sights. If you're interested in something, come out on a Saturday and see the mods on my guns, my Sig SEALS is nice too! I can also change cheap screws and hardware for aircraft stuff ( think 'titanium') and add or install anything external that you buy so that it looks good.
|
|
|
|
Post by dave OC-6 on Aug 22, 2010 20:15:20 GMT -5
ewwwww french army stuff, make it go away.
|
|
|
|
Post by heinous on Sept 6, 2010 20:50:48 GMT -5
OK, Repairs done today since end of play this afternoon. Hysteria's RPK, front sights re-tapped and locked in place, front barrel end section tapped and locked in place, repaired bolt-plate/dust cover/side rail to original condition, thread locked all screws. Jason's PIG, Manufactured new wire harness, heat shrunk and placed in weapon awaiting dean connectors, tightened/adjusted all screws, removed bi-pod to use machine shop at work to repair. My M14- re-re-repaired my hop-up unit with steel parts this time and am getting very consistent groups now. I'm off to bed.
|
|
|
|
Post by hysteria on Sept 6, 2010 20:53:45 GMT -5
I found my m16/m4 hopup. Its full metal and seems to be in good condition. Thanks for the work.
|
|
|
|
Post by heinous on Sept 6, 2010 20:55:38 GMT -5
That's good news, I also sent you a PM about the work. Just a repeat of this post. That'll make installing the new TBB instant. Open the upper pull inner barrel with hop up, install new TBB with the hop up already installed and go to battle. putting the hop up on the TBB makes it a straight swap.
|
|
|
|
Post by heinous on Sept 8, 2010 19:52:28 GMT -5
The M60 bi-pod leg retaining tab repair before paint
|
|
|
|
Post by heinous on Sept 8, 2010 19:53:32 GMT -5
The M60 bi-pod leg retaining tab repair after paint
|
|
|
|
Post by dave OC-6 on Sept 8, 2010 20:06:44 GMT -5
ok what are we looking at?
|
|
|
|
Post by heinous on Sept 19, 2010 12:28:09 GMT -5
This is what happens when you have a high end gearbox/motor and a stock piston face. Explosion in piston tube and chunks in your gears. Dave's poor Galil was a casualty of Cybergun's acquisition of high end parts companies. They put a superb gearbox/motor/120spring on a stock piston set-up. A soft zytel fiber 2 piece piston face cannot handle those pressures. Will be getting a reinforced piston face this week so we can shoot at him later.
|
|
|
|
Post by dave OC-6 on Sept 19, 2010 15:05:58 GMT -5
It hurts to look at
You better treat her right.
Next game day I will play a game.
|
|
